Product ID:F-133-P COMPRESTO-POXY PRIMER
MSDS Date:10/22/1986
FSC:8030
NIIN:00N032251
MSDS Number: BNSMS

RANDUSTRIAL CORP

13311 UNION AVE
CLEVELAND, OH 44120
US

Emergency Phone: 216-283-0300

Info Phone: 216-283-0300

Cage: HO267

RANDUSTRIAL CORPORATION

CLEVELAND, OH 44135 US

Telephone: 216-641-7500

Cage: HO267

ASPHALTIC CONCRETE OR PETROLEUM ASPHALT; (PETROLEUM

Fraction By Weight: 65%

WATER

CAS: 7732-18-5

RTECS: ZC0110000

Fraction By Weight: 27%

PETROLEUM DISTILLATE

Fraction By Weight: 6%

CARBOXYLATE SOAP(INGREDIENT 4 & 5 ARE PRESENT IN PRODUCT AS

Fraction By Weight: SEE ING

VISCOSITY BUILDER; (INGREDIENT 4 & 5 ARE PRESENT IN PRODUCT

Fraction By Weight: SEE ING

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES:EXPECTED TO CAUSE NO MORE THAN
MINOR EYE IRRIT. SKIN:EXPECTED TO PRDCE NO MORE THAN MINOR SKIN
IRRIT BUT PRLNGD/ FREQUENTLY RPTD SKIN CONT MAY BE HARMFUL.
INHAL/INGEST:NOT EXPECTED TO BE ACUTELY TOXIC. NO ASSOC HAS BEEN
ESTABLISHED BETWEEN INDUS EXPOS TO PETRO ASPHALT & CANCER IN
HUMANS. ASPHALTS (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:CONTAIN SMALL AMTS OF POLYNUCLEAR
AROMATIC HYDROCARBONS WHICH, WHEN CONCENTRATED, HAVE BEEN SHOWN TO
CAUSE SKIN CANCER IN MICE AFTER PRLNGD/FREQUENT CONT.
BRIEF/INTERMITTANT SKIN CONT W/THIS ASPHALT PROD IS NOT EXPECTED
TO PRDCE ANY SERIOUS EFTS. WHILE NORM HNDLG OF PROD IS NOT LIKELY
TO CAUSE CANCER (SUP DAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYES:WASH W/FRESH WATER FOR AT LEAST 15 MINS. IF IRRIT
CONTINUES, SEE MD. SKIN:REMOVE HEAVILY CONTAMD CLTHG & WASH SKIN
THORO W/SOAP & WATER. DO NOT USE SOLVENTS OR THINNER TO REMOVE MATS
FROM SKIN. A SPHALT CAN BE REMOVED W/VEGETABLE OIL OR MINERAL OIL.
INHAL: REMOVE TO FRESH AIR. SUPPORT BRTHG (GIVE O2/ARTF RESP) .
INGEST:GIVE A LGE AMOUNT OF WATER TO DRINK, MAKE PERS VOMIT & CALL
MD.

Extinguishing Media:CO2, DRY CHEMICAL, FOAM & WATER SPRAY.
Fire Fighting Procedures:WEAR NIOSH/MSHA SCBA & FULL PROTECTIVE EQUIP
BEFORE ENTERING ANY ENCLOSED/CONFINED FIRE SPACE. SEE HAZARDOUS
DECOMPOSITION PRODUCTS. READ ENTIRE MSDS.
Unusual Fire/Explosion Hazard:NONE.

Spill Release Procedures:CLEAN UP SPILLS ASAP, OBSERVING PRECS IN SPEC
PROT INFO & LBL. PLACE SPILLED MATL IN DISPOSABLE CONTRS. HYDROCARB
MATL SUCH AS KEROSENES/MINERAL OIL CAN BE USED TO DISSOLVE
REMAINING MATL. THIS MATL M AY BE ABSORBED W/ABSORB
CLAY/DIATOMACEOUS EARTH.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:READ/OBSERVE ALL PRECAUTIONS ON PROD
LABEL. DO NOT WELD, HEAT OR DRILL CONTR. REPLACE CAP OR BUNG.
Other Precautions:EMPTIED CONTR STILL CONTAINS HAZ MATL WHICH MAY
IGNITE W/EXPLOS VIOLENCE IF HEATED SUFFICIENTLY. AVOID CONT W/EYES.
AVOID PRLNGD/ RPTD SKIN CONT W/THIS MATL. KEEP OUT OF REACH OF
CHILDREN. DO NOT USE PRESS TO EMPTY DRUM OR EXPLOS MAY RSLT.

Respiratory Protection:NO SPECIAL RESPIRATORY PROTECTION IS NORMALLY
REQUIRED. HOWEVER, IF OPERATING CONDITIONS CREATE HIGH AIRBORNE
CONCENTRATION, THE USE OF A NIOSH/MSHA APPROVED RESPIRATOR IS
RECOMMENDED.
Ventilation:USE THIS MATERIAL ONLY IN WELL VENTILATED AREAS.
Protective Gloves:RUBBER GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:SKIN CONTACT MAY BE MINIMIZED BY WEARING
IMPERVIOUS PROT CLOTHING. WASHING FACILITIES FOR SKIN SHOULD BE
AVAIL NEARBY.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EFTS OF OVEREXP:IN HUMANS, SKIN CONTACT & BREATHING OF MISTS, FUMES OR
VAPORS SHOULD BE REDUCED TO A MINIMUM. WE STRONGLY RECOMMEND THAT
THE PRECAUTIONS OUTLINED IN THIS MSDS BE FOLLOWED WHEN HANDLING
MATERIAL.

HCC:B3
Boiling Pt:B.P. Text:212F,100C
Melt/Freeze Pt:M.P/F.P Text:>30F,>-1C
Vapor Pres:60 @ 100F
Spec Gravity:0.98 @ 15.6C
pH:7-10
Solubility in Water:READILY DISPERSIBLE
Appearance and Odor:DARK TO TAN LIQUID.
Percent Volatiles by Volume:27

Stability Indicator/Materials to Avoid:YES
MAY REACT W/STRONG OXIDIZING MATERIALS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:NORMAL COMBUSTION FORMS CO2 & WATER
VAPOR & MAY PRDCE OXIDES OF SULFUR; INCOMPLETE COMBUSTION CAN
PRODUCE CO.

Waste Disposal Methods:PLACE CONTAMINATED MATERIALS IN DISPOSABLE
CONTAINER & BURY IN AN APPROVED DUMPING AREA. DISPOSAL MUST BE IN
ACCORDANCE W/FEDERAL, STATE & LOCAL REGULATIONS .

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.